I have everything working on the box before sending it off to Africa. All development was done through the LAN connection. One very last test was to power down the RACHEL box, bring it up again, and go through my tests over wifi.
The SSID I’ve given it appears for a few seconds, then disappears, then never reappears again until I’ve gone into Wireless Settings and done a SAVE with the existing parameters. Then the SSID works fine until the next time I power down.
And all the time the Wireless Status always brings me back to the login page, it doesn’t show me any wireless status.
The box leaves for the airport in about 30 minutes, so I cannot make a change before it gets to Tanzania, but once it is there I can connect to it and make any modifications you recommend.
Thanks for any guidance on what might be wrong. This is 2015 hardware with the April 20, 2017 image loaded with Method=3.